Save Surface Data
Workflow
The process of configuring this Step is shown below:
-
Configure the input. Connect the Step ports in the graphical programming workspace or select the input under Input in the parameter configuration panel.
-
Set the file type and storage path for data to be saved.
-
Set other parameters.
-
After Run Step, you can view saved files in the specified path.
Parameters
| Parameter | Description | ||
|---|---|---|---|
Save as Type |
Select the file type to save the surface data. Value list: MRAW file (.mraw), PLY file (.ply) |
||
Storage Path |
The storage path of files. |
||
Custom Prefix of Image Files |
Set prefix for image files. |
||
Auto-Delete Old Data When Space Is Low |
When saving image data, the system will delete old data automatically if space is low.
|
||
Normal Search Radius |
Points within a circle with the set search radius will be used to calculate normals. The unit is millimeters (mm). The default value is 1.000. |
||
Half Kernel Size |
Points within a square with a side length twice the set half kernel size will be used to calculate the normals. The unit is pixels (px), and the default value is 5. |
Troubleshooting
See Error Code List for common error messages and solutions.