Feature Region

Feature regions define the target regions of processing during Step runs.

Set a Feature Region

In some Steps, you can adjust the feature regions directly, while in others, you need to select the Use Feature Region parameter first under “Parameters” and then adjust the feature regions.

You can set the feature region in the following ways:

Adjust Feature Region in Data Viewer Area

This method is used to roughly adjust the feature region(s).

  • Adjust the position of a feature region

    1. Press and hold the Ctrl key to activate the feature region. Green squares will be displayed on each edge of the feature region.

    2. Long press the left mouse button on any plane of the feature region to be moved. Yellow arrows will appear on each side.

    3. Move the mouse in any direction to move the feature region. Release the left mouse button to complete the adjustment.

move feature region

  • Adjust the size of a feature region

    1. Press and hold the Ctrl key to activate the feature region. Green squares will be displayed on each edge of the feature region.

    2. Press and hold the left mouse button on any green square, and the square will turn yellow.

    3. Move the mouse in any direction to adjust the size of the feature region. Release the left mouse button to complete the adjustment.

adjust feature region

Set Feature Region Parameters in the Parameter Configuration Panel

This method is used to fine-tune a feature region. In some Steps, you can set a feature region only when the Use Feature Region option is selected.

feature region settings

  • Feature Region

    • Add a feature region: Click + Add Feature to add a new feature region.

      If this button is greyed out in a Step, it means that the Step does not support the creation of a new feature region or the number of created feature regions has reached the upper limit.

    • Expand Region1 (Example): Click ▶ to expand Region1.

      • Region Type: The feature region. The options are cuboid, cylinder, and elliptic cylinder.

      • Center X/Y/Z: The center position of the feature region.

      • Width (X) / Length (Z) / Height (Z): The dimensions of the feature region.

      • Rotation Angle: The angle at which the feature region rotates counterclockwise around the Z-axis of the spatial reference frame in its initial position.

    • Delete a feature region: Click delete icon to the right of Region2 (example) to delete this feature region. If the delete icon is grayed out, the feature region cannot be deleted.

The parameters of a feature region may differ from Step to Step. Please adjust the relevant parameters according to the actual display of the interface.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept