Configure Communication in Mech-MSR

This section introduces how to set up the communication between Mech-MSR and an external device to control project operation and transfer data.

Through Communication Protocols

After configuring the communication and enabling the communication service in the Communication Configuration window of Mech-MSR, you can use an external device, such as a PLC, to trigger a Mech-MSR project to run and obtain measurement and inspection results.

It is recommended to manage output before communication configuration.

Configure communication in Mech-MSR based on the selected protocol:

Through I/O Terminals

You can use the laser profiler I/O terminals to trigger a project and obtain quality judgements results. See detailed information in Configure Laser Profiler I/O Terminals.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.