DOBOT

You are viewing an old version of the documentation. You can switch to the documentation of the latest version by clicking the top-right corner of the page.

This guide shows you how to set up Master-Control communication with a DOBOT robot.

Check Controller and Software Compatibility

Controller software version : 3.5.2 or above.
Mech-Mind Software Suite version: 1.6.0 or above.

Set up the Network Connection

Connect the Hardware

Plug one end of the Ethernet cable into the network port of the IPC and the other end into the network port of the robot controller.

① is the network port of the robot controller.

Set the IP Address

To allow communication between the IPC and the robot controller, the IPC’s network port connected to the robot controller should be in the same subnet as the robot. This means that the network portions and subnet masks of the IP addresses should be the same. For example, 192.168.100.1/255.255.255.0 and 192.168.100.2/255.255.255.0 are in the same subnet.

Set Camera IP Address.
Set Robot IP address.
- If the robot controller software is DobotSCStudio, set the IP address according to the following steps.
  
  In DobotSCStudio, go to system ToolConfigure NetworkSetting Auto IP Address Save.
  
  If the IP address isn’t in the same subnet as the IPC, select Manual IP Address and set the IP address manually, and click Save .
- If the robot controller software is DobotStudio, set the IP address according to the following steps.
  
  In DobotStudio, go to Settings Communication settings Get IP automatically, enter the IP address, netmask and default gateway, and click Apply.

Switch to Remote Control Mode (only required by DobotStudio software)

In DobotStudio, click Settings Remote Control, select TCP/IP Secondary development for Current mode, and click Apply.

Cautions

Do NOT use Mech-Viz and DobotSCStudio/DobotStudio software at the same time. Otherwise Mech-Viz may not connect to the robot properly.
Do not use Mech-Viz when operating the teach pendant.
It is suggested to remove the Wi-Fi USB device connected to the controller since the device may affect remote control.
When master-controlling the DOBOT robot, Mech-Viz does not support setting the robot’s TCP during the project. Therefore, please make sure that the TCP value on the robot side is consistent with the TCP set in Mech-Viz. Otherwise, the real robot’s linear move path will differ from the planned path of Mech-Viz. Users can perform the following steps to make the TCP values consistent:
1. Modify the TCP value on the robot side manually to match the TCP set in Mech-Viz;
2. Move the Robot;
3. Reconnect the robot to Communication Component.
The DI value of the DOBOT robot is one greater than that in Mech-Viz. For example, DI1 of the real robot corresponds with DI0 in Mech-Viz.

Test Robot Connection

Please refer to Test Robot Connection.