Power the Vision System On and Off
To ensure that users new to the Vision System can quickly get up to speed and maintain smooth production on-site, the following sections will detail the operating procedures for direct operators, front-line personnel, technicians, engineers, and other relevant users.
Power On the Vision System
-
Before powering on the Vision System, ensure that the IPC on-site is connected to a power source. The IPC typically powers on automatically when connected to power, reducing the need for manual operation.
-
Press the Power button
on the IPC to complete the startup process. The Vision System will automatically launch after the IPC is powered on.
-
If the monitor does not turn on a few minutes after completing the above steps, please follow the procedures below to check:
-
Check if the power indicator
of the IPC is solid on. -
Check if the power indicator of the monitor is solid on.
-
-
After the IPC starts up, it is usually configured to automatically launch the Vision software and minimize the interface window. At this time, you need to find the Mech-Vision icon, and left-click it to open the Mech-Vision interface.
-
View the Menu bar and the Log-Console interface to verify if the project has loaded correctly and if the communication connections are functioning properly.
Illustration Description:
-
Project loaded successfully
-
Camera connected successfully
-
Communication activated successfully
-
Power off the Vision System
-
When the IPC needs to be shut down, first close the Vision System. Right-click on theMech-Vision and Mech-Viz (ignore if the Viz software is not used) icons in the lower-right corner of the desktop, then select Exit Mech-Vision / Exit Mech-Viz to close the Vision software.
-
When closing the vision software, you may be prompted to Save Changes. If you need to save the changes, click Save; if you do not need to save them, click Discard, and the software will then be closed.
-
After closing the Vision software, select Power in the Start menu bar of the IPC, and then click Shut down.
