Start Interface Service

You are currently viewing the documentation for version 1.8.2. To access documentation for other versions, click the "Switch Version" button located in the upper-right corner of the page.

■ To use the latest version, visit the Mech-Mind Download Center to download it.

■ If you're unsure about the version of the product you are using, please contact Mech-Mind Technical Support for assistance.

This section introduces how to start the interface service.

In the main window of Mech-Vision, click the “Robot Communication Configuration” switch on the toolbar. The interface service will be enabled as shown in the following figure.

start communication start

If the interface service is started successfully, log “Start xxx interface” will be displayed under the Console tab of the Mech-Vision log panel.

If the interface service fails to be started, please check the robot communication configuration.

We Value Your Privacy

We use cookies to provide you with the best possible experience on our website. By continuing to use the site, you acknowledge that you agree to the use of cookies. If you decline, a single cookie will be used to ensure you're not tracked or remembered when you visit this website.

  • Preference
  • I accept
  • I don't accept